DAQ BNC-2090 Manual do Utilizador descarregar pdf (Página 12)



National Instruments Corporation 2-1 BNC-2090 User Manual

Configuration, Installation,

and Signal Connection

Chapter

This chapter explains how to configure the switches and jumper on the

BNC-2090, install the BNC-2090, and connect signals to the accessory.

Configuring Your BNC-2090

Your BNC-2090 is factory-configured. However, you must reconfigure

your accessory if you want to do any of the following:

• Use your BNC-2090 with a MIO board configured for RSE or

NRSE mode

• Connect the BNC-2090 shield directly to digital ground (DGND)

• Use a PC-LPM-16 as the BNC-2090 power source

• Condition your signals (Refer to Chapter 3,

Signal Conditioning

Application Examples

)

Figure 2-1 shows the front and back panels of the BNC-2090.

Figure 2-1.

BNC-2090 Rack-Mount Breakout Accessory

1 SW1

4 Spring Terminal Blocks

2 SW9

5 Power Switch

3 68-Position Connector

5 3

1 2 3 4

Rear Panel

Front Panel

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 54 55

Sem comentários

DAQ BNC-2090 Manual do Utilizador Página 12